Prochem Blazer GT Manuel d'utilisateur télécharger pdf (Page 39)

Maintenance

* Or as often as required

** Change solution pump crankcase oil after the first 50 hours

***Change engine crankcase oil and filter after the first 8 hours

****Perform drive belt, pulley and hub maintenance after the first 25 hours of operation, and then again at 100

hours

*****If using Tuthill Pneulube synthetic lubricant, 4500 hours or every 2 years, whichever comes first

Vacuum pump 250 hrs Lubricate bearing on pulley end with grease

Vacuum Exhaust Heat Exchanger 500 hrs Inspect cores and remove debris.

Solution Pump 500 hrs Change oil**

Pulley Set Screws & Hub Cap Screws 500 hrs Check for proper torque values. Re-torque, if

required****

Drive Pulley 500 hrs Inspect, clean and check for pulley groove wear****

Drive Pulley 500 hrs Check pulley alignment****

Drive Belts 500 hrs Inspect and clean****

Drive Belts 500 hrs Check belt tension****

Chemical Pump & Check Valves 500 hrs Replace diaphragm, plastic disk and check valves.

Vacuum Lubrication Lines 500 hrs Check for line obstructions. Replace tubing if cracked or

damaged

Engine 500 hrs Replace in-line fuel filter on engine.

Engine 1000 hrs Replace spark plugs.

Check Valve (Solution Outlet) 1000 hrs Inspect, clean, and repair, if needed.

Waste Tank Shut-off Float Switch Monthly Check for debris hindering movement

Vacuum pump Yearly Drain and replace oil*****

Waste Tank Filters/Strainers Yearly Check for damage and blockage. Replace if needed.

Engine Yearly Replace air cleaner element

Engine 3 years Replace ignition wires.

86317260 BLAZER GT

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 131 132

Pas de commentaire

Prochem Blazer GT Manuel d'utilisateur Page 39